Call: Tel. 0966 924868, 0118 547336

Advantages and Disadvantages of Ready-Mix Concrete

Advantages and Disadvantages of Ready-Mix Concrete

RMC is more environmentally friendly than site mix concrete since it is mixed in confined chambers, which decreases noise and pollution.

RMC is a type of concrete, which is a mixture of Portland Cement, Water, Fine (Sand) and Coarse aggregates. It is manufactured in a cement factory or batched plants in specific proportions and transported in a Transit-mixer to the construction sites.

Types of Ready-Mix-Concrete

There are three types of ready-mix concrete, and they are briefly presented below:

Transit mixed concrete

It is also known as truck mixed concrete, in which materials are batched at a central plant and are thoroughly mixed in the truck in transition. Transit-mixing separates water from the cement and aggregates and allows the concrete to be mixed instantly before using it at the job site.

Transit-mixing avoids the problems of early hardening and slump loss that result in delays in transportation. The disadvantage is the capacity of the truck is smaller than the same truck carrying central-mixed concrete.

Shrink-mixed concrete

It is used to increase the truck’s load capacity where concrete is mixed at the plant to shrink the volume of the concrete. The balance mixing of concrete is completed in the truck during transit time or at the construction site.

Central-mixed concrete

Sometimes, the central mixed plants are referred to as wet batch plants. The concrete is batched and completely mixed in a stationary mixer at the plant site before discharging it into the truck mixers.

The advantages of central-mixed concrete are better quality control, consistency, higher production capability, and reduced wear on the truck mixer drums.

 RMC was first used for the construction of Bhakra Nangal Dam Project in Bilaspur, Himachal Pradesh.

The volumetric mobile mixer is also a truck that contains raw materials and water, which can be mixed on the truck at the job site. The on-truck mixing at the job site eliminates the problems of ready-mix concrete.

Advantages of Ready-Mix Concrete

  •  Better quality concrete is produced as it is made from consistent methods and in advanced equipment.
  •  No need to store construction materials at the site.
  •  Labour associated with the production of concrete is eliminated, thereby reducing labour cost.
  •  Air and Noise pollution at the job site is reduced.
  •  Wastage of basic materials at the site is avoided.
  •  Reduce the time required for construction.
  •  No delays in completing major projects like constructing dams, roads, bridges, tunnels, etc.
  •  Economy in the use of raw materials results in conservation of natural resources.
  •  Safe work practices – No disruption in the project schedules.
  •  Environment-friendly.

Disadvantages of Ready-Mix Concrete

  •  Requires huge initial investment.
  •  Not suitable for small projects (less quantity of concrete is required).
  •  Need an effective transportation system from the batching plant to the job site.
  •  Labour should be ready at the site to cast the concrete in position without any delay to avoid slumps in the mixture.
  •  Concrete has limited time and should be used within 210 minutes of batching the plant. Traffic jam or breakdown of the vehicle can create a problem.

Quality Control is very important as it has to be mixed with a proper dose of admixtures and transported to different locations. All the ingredients used for the mixture of concrete are thoroughly tested for quality and physical properties based on Indian Standard Codes. Everything is taken care of by batching plants while manufacturing the concrete mixture to produce highly durable, sustainable, and premier quality for long-lasting structures.

Ethiopia Construction
Logo